- Community Development
- Stormwater Management
- Post-Construction Requirements
Post-Construction Storm Water Management Requirements
On July 13, 2013, the Central Coast Regional Water Quality Control Board adopted Post-Construction Storm Water Management Requirements (PDF) (Resolution R3-20132-0032025).
Post-Construction Storm Water Compliance
The Central Coast Regional Water Quality Control Board recognizes that it is necessary to protect watershed processes so that beneficial uses of receiving waters are maintained and, where applicable, restored. The primary objective of these Post -Construction Stormwater Management Requirements is to ensure reduction of pollutant discharges to the Maximum Extent Practicable and preventing stormwater discharges from causing or contributing to a violation of receiving water quality standards in all applicable development projects that require approvals and/ or permits issued under the planning, building or other comparable authority. To address the impacts of development on water quality, the National Pollutant Discharge Elimination System (NPDES) Small Municipal Separate Storm Sewer System (MS4) General Permit requires the City of Arroyo Grande to develop and implement a Guidance Document that includes specific Best Management Practices (BMPs).
Regulated Projects include all New Development or Redevelopment projects that create and/or replace ≥ 2,500 square feet of impervious surface (collectively over the entire project site).
If the project is considered to be a regulated project, the project will be required to at least meet Performance Requirement 1 (PR 1). Many regulated projects are required to meet additional performance requirements. To determine if the project must meet additional requirements, you must determine the Net Impervious Area.
The Net Impervious Area is the total ( including new and replaced) post-construction impervious areas, minus any reduction in total imperviousness from the pre-project to post-project conditions. Permeable pavements may only be excluded from the impervious surface area calculation if they are designed to infiltrate.
Projects that are determined to meet additional Performance Requirements will also be required to complete a Stormwater Control Plan (SWCP), using the provided template.
Non-regulated project types can be found in Resolution Number R3- 2013- 0032 (PDF), Section B. Post - Construction Requirements subsection 1b. Typically, maintenance and utility projects are considered non-regulated projects under post-construction requirements as specified by the Regional Board.
Examples of non-regulated maintenance projects include routine overlays and slurry seals. Examples of non-regulated utility projects include:
- Installation of an ADA ramp
- Solar panels on rooftops
- Repair of roads or aerial utilities
If the project meets the criteria to be considered non-regulated, project applicants are still encouraged to implement practices that will reduce stormwater impacts associated with their proposed development.
Review the Central Coast Regional Water Quality Control Board Post-Construction Storm Water Management Requirements (PDF) (Resolution R3-20132-0032025) for applicable performance requirements.